An engineer once sent us a board that had passed every electrical test his team could throw at it: in-circuit test, functional test, and a week of burn-in. Six months into the field, units started coming back with cracked ceramic capacitors and one intermittently open BGA. The schematic and solder were fine. The failure analysis traced it to the assembly step that nobody had questioned: The board was being ultrasonically staked into its housing, and every unit had taken a dose of 20 kHz vibration inches from its most fragile components. High-frequency vibration has its place in assembling plastic components, but next to a ceramic capacitor, it may as well be a paint mixer.
The fix was to move the joint to heat staking—heat and steady pressure on the stud, no vibration—and the returns stopped. Heat staking is one of the most common ways a PCB ends up mounted in a plastic enclosure, and it is routinely the last thing we think about. The mechanical engineer picks the process after the board is released; the manufacturing engineer inherits whatever geometry shipped; and the circuit designer—the one person who could have made the joint reliable for free—usually hears about it for the first time at a failure analysis meeting.
The Process in 60 Seconds
Heat staking forms a permanent mechanical joint out of material the enclosure already has. A thermoplastic stud, molded as an integral feature of the housing, usually on top of a boss, passes through a clearance hole in the PCB. A heated tool softens the stud and forms it into a head roughly twice the stud's diameter, holding it under pressure while it cools and solidifies. The formed head captures the board, much like a rivet head captures a plate.1
Modern equipment runs an impulse cycle: heat, form, and cool under pressure, then retracts with a cooled tip so the plastic releases cleanly rather than sticking or stringing. When done right, the result is a smooth dome that keeps the board flat against its standoffs for the life of the product.
To continue reading this article, which appeared in the November 2026 SMT007 Magazine, click here.