-
- News
- Books
Featured Books
- pcb007 Magazine
Latest Issues
Current IssueThe Essential Guide to Surface Finishes
We go back to basics this month with a recount of a little history, and look forward to addressing the many challenges that high density, high frequency, adhesion, SI, and corrosion concerns for harsh environments bring to the fore. We compare and contrast surface finishes by type and application, take a hard look at the many iterations of gold plating, and address palladium as a surface finish.
It's Show Time!
In this month’s issue of PCB007 Magazine we reimagine the possibilities featuring stories all about IPC APEX EXPO 2025—covering what to look forward to, and what you don’t want to miss.
Fueling the Workforce Pipeline
We take a hard look at fueling the workforce pipeline, specifically at the early introduction of manufacturing concepts and business to young people in this issue of PCB007 Magazine.
- Articles
- Columns
Search Console
- Links
- Media kit
||| MENU - pcb007 Magazine
Estimated reading time: Less than a minute

Contact Columnist Form
Trouble in your Tank: Optimizing the Liquid Photoimageable Soldermask Process, Part 1
Introduction
Some of my recent columns in have focused on identifying and resolving some very specific technical issues related to soldermask. It would be prudent at this time to present information on the soldermask process itself in hopes of preventing defects in the future. But first, one should understand the key requirements for the soldermask, in particular for today’s lead-free assembly requirements and fine-pitch circuitry.
The Requirements
Increased wiring density is driving soldermask performance to levels never seen before. Requirements to hold 2 and 3 mil dams are commonplace, especially with the increased use of HDI technology. In addition, PCB end-users are requiring the soldermask to display higher electrical and environmental properties as well as perform effectively with the myriad of lead-free solderable finishes (ENIG, Selective ENIG-OSP, ENEPIG, lead-free HASL, immersion silver and immersion tin).
Soldermask is applied after the surface traces are formed. The challenge for these materials is to impart electrical properties where, historically, soldermask was not part of electrical design. Soldermask attributes are shown in Table 1. (Source: IPC Technology Roadmap 2013)
Editor's Note: This article originally appeared in the May 2013 issue of The PCB Magazine.
More Columns from Trouble in Your Tank
Trouble in Your Tank: Interconnect Defect—The Three Degrees of SeparationTrouble in Your Tank: Things You Can Do for Better Wet Process Control
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 5
Trouble in Your Tank: Materials for PWB Fabrication—Drillability and Metallization
Trouble in Your Tank: Supporting IC Substrates and Advanced Packaging, Part 5
Trouble in Your Tank: Electrodeposition of Copper, Part 6
Trouble in Your Tank: Electrolytic Copper Plating, Part 5
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 4