Dan’s Biz Bookshelf: ‘Believe in Better'
The Big Picture: Our Big ‘Why’ in the Age of AI
The Chemical Connection: Through-glass Vias in Glass Substrates
Estimated reading time: Less than a minute
Connect:
May 21, 2013
Trouble in Your Tank: The Root Cause of ICDs, Part II
One can never get enough of a bad thing. And that applies to circuit board fabrication and technical issues such as ICDs. In the September 2012 Trouble in Your Tank column in this magazine, I summarized the different types of ICD and even covered an actual case history. In Part II, I present another case study and again challenge the reader to test his or her troubleshooting skills.
This article originally appeared in the March 2013 issue of The PCB Magazine.
Share on:
More Columns from Trouble in Your Tank
Trouble in Your Tank: Yield Improvement and ReliabilityTrouble in Your Tank: Causes of Plating Voids, Pre-electroless Copper
Trouble in Your Tank: Organic Addition Agents in Electrolytic Copper Plating
Trouble in Your Tank: Interconnect Defect—The Three Degrees of Separation
Trouble in Your Tank: Things You Can Do for Better Wet Process Control
Trouble in Your Tank: Processes to Support IC Substrates and Advanced Packaging, Part 5
Trouble in Your Tank: Materials for PWB Fabrication—Drillability and Metallization
Trouble in Your Tank: Supporting IC Substrates and Advanced Packaging, Part 5
Copyright © 2025 I-Connect007 / Global Electronics Association Publishing Group All rights reserved.
Log in