-
- News
- Books
Featured Books
- pcb007 Magazine
Latest Issues
Current IssueThe Essential Guide to Surface Finishes
We go back to basics this month with a recount of a little history, and look forward to addressing the many challenges that high density, high frequency, adhesion, SI, and corrosion concerns for harsh environments bring to the fore. We compare and contrast surface finishes by type and application, take a hard look at the many iterations of gold plating, and address palladium as a surface finish.
It's Show Time!
In this month’s issue of PCB007 Magazine we reimagine the possibilities featuring stories all about IPC APEX EXPO 2025—covering what to look forward to, and what you don’t want to miss.
Fueling the Workforce Pipeline
We take a hard look at fueling the workforce pipeline, specifically at the early introduction of manufacturing concepts and business to young people in this issue of PCB007 Magazine.
- Articles
- Columns
Search Console
- Links
- Media kit
||| MENU - pcb007 Magazine
Estimated reading time: 1 minute

Testing Todd: How are the Ratings?
Hello, readers! Thank you for stopping by again. Let’s talk about ratings. No, I’m not talking about the latest Facebook likes or Twitter retweets, but a topic that confuses many final QA technicians the world over. I’m talking PCB voltage ratings.
If you are an electrical test engineer/technician, I’m sure you have seen many master drawings that use the term “Maximum Rated Voltage is XXX Volts,” where XXX is a number.
I have seen many final inspection areas that will reject a final ET certificate of compliance (CoC) because they read the master drawing and see a statement such as “maximum rated voltage = 24V” but the CoC says it was tested at 250 volts! The manufacturing specification is also stated as IPC-6012D(DS). Is the CoC wrong? In most cases, no. “Todd, can this be?” you ask. Well, in this case, it is correct.
Master drawings carry a gambit of information for the manufacture of printed circuits. Many notations are specific instructions and call-outs for the PWB. However, there are many “statements” on the master drawing as well. The term “maximum rated voltage” is one of those statements. In many cases, when you read that statement, you can think, “Thank you for that. Good to know.” Does that mean that I have to test that PWB at the rated voltage? In many cases the answer is no.
What that statement is telling you is that in that PCB’s duty cycle (life) it will never see a voltage higher than what is stated. Again, good to know, right?
To read the full version of this article which appeared in the April 2018 issue of PCB007 Magazine, click here.
More Columns from Testing Todd
Testing Todd: Why 4-wire Kelvin?Testing Todd: Why TDR?
Testing Todd: Positivity Boosts Employee Morale
Testing Todd: Preparing Employees for the Long Haul
Testing Todd: Where Can We Improve?
Testing Todd: Turning Into the Wind
Testing Todd: Coming Back to Life—Design Recovery
Testing Todd: Decision Time—Invest or Delegate?