The Government Circuit: Three Inescapable Conclusions About Global Trade Policies
Global Citizenship: The Global Push for Digital Inclusion
Knocking Down the Bone Pile: Addressing End-of-life Component Solderability Issues, Part 4
All About That Route: Design007 Magazine June 2025
June 9, 2025 | I-Connect007 Editorial TeamEstimated reading time: Less than a minute
Do you prefer manual routing or autorouting? That might be a loaded question. Maybe you’re one of the designers who performs manual routing with an autorouter. Most designers favor manual routing, but today's interactive autorouters may be changing designers' minds by allowing users more direct control.
In the June 2025 issue of Design007 Magazine, our expert contributors discuss a variety of manual and autorouting strategies. EDA company product managers also weigh in on their latest autorouting technologies, and they explain how designers can exercise a high level of direct control or allow full automation through interactive AI.
Share on:
Suggested Items
The Pulse: Design Constraints for the Next Generation
07/17/2025 | Martyn Gaudion -- Column: The PulseIn Europe, where engineering careers were once seen as unpopular and lacking street credibility, we have been witnessing a turnaround in the past few years. The industry is now welcoming a new cohort of designers and engineers as people are showing a newfound interest in the profession.
Meet the Author Podcast: Martyn Gaudion Unpacks the Secrets of High-Speed PCB Design
07/16/2025 | I-Connect007In this special Meet the Author episode of the On the Line with… podcast, Nolan Johnson sits down with Martyn Gaudion, signal integrity expert, managing director of Polar Instruments, and three-time author in I-Connect007’s popular The Printed Circuit Designer’s Guide to... series.
Elementary, Mr. Watson: Rein in Your Design Constraints
07/10/2025 | John Watson -- Column: Elementary, Mr. WatsonI remember the long hours spent at the light table, carefully laying down black tape to shape each trace, cutting and aligning pads with surgical precision on sheets of Mylar. I often went home with nicks on my fingers from the X-Acto knives and bits of tape all over me. It was as much an art form as it was an engineering task—tactile and methodical, requiring the patience of a sculptor. A lot has changed in PCB design over the years.
Facing the Future: Time for Real Talk, Early and Often, Between Design and Fabrication
07/08/2025 | Prashant Patel -- Column: Facing the FutureThere has always been a subtle but significant divide between those who design and those who build printed circuit boards. It’s not a hostile gap, but it is a real one, and in today’s high-speed, high-complexity, high-stakes environment, that gap is costing us more than time and yield. It’s costing us innovation.
Elementary Mr. Watson: Retro Routers vs. Modern Boards—The Silent Struggle on Your Screen
06/26/2025 | John Watson -- Column: Elementary, Mr. WatsonThere's a story about a young woman preparing a holiday ham. Before putting it in the pan, she cuts off the ends. When asked why, she shrugs and says, "That's how my mom always did it." She asks her mother, who gives the same answer. Eventually, the question reaches Grandma, who laughs and says, "Oh, I only cut the ends off because my pan was too small." This story is a powerful analogy for how many PCB designers approach routing today.
Copyright © I-Connect007 | IPC Publishing Group Inc. All rights reserved.
Log in